The manual describes the bolt which holds the counter balancer gear on as a "special bolt".
Is this a left hand thread bolt??
The 41mm nut which holds the gear on crank to drive the counter balancer gear is this one
a left or right hand thread??
I just wana make sure before I get rammy.

Both are righty tighty
Even in Canada

I picked up a 41mm deep 1/2" drive impact socket off of ebay

Brrrrpppp brrrrppppp and easy as that

Just hold the gears lashed to avoid hammering

righty tighty even in Canada --- well I don't know about that cause we're a bit commie up here and
that means lefty lefty.
Will make a wrench like the one in the manual though.
Thanks for the info.