In the process of re&re the front brake drums for Christine.
This is all the scrap from the parts machine I bought years ago.
Pics below for anyone who has not taken one apart and for just info purposes.
Pics will show the dimensions of the spacer in the middle and you will also notice that you can not just drive everything out from one end as there is three tits inside that would prevent you from doing that.
I am going to be reusing the seals because you can take them out without damage. They are both still available and are used on many other machines. Also these are basically just dust/water seals anyways because the bearings are 2RS. Put a bit of red silicone on the outside when you put it back in to make sure it stays in place.
| Attachments: |
|
20171125_215720.jpg [ 50.28 KiB | Viewed 280 times ] |
|
20171125_215756.jpg [ 55.05 KiB | Viewed 280 times ] |
|
20171125_220247.jpg [ 57.48 KiB | Viewed 280 times ] |
|
20171125_220439.jpg [ 46.24 KiB | Viewed 280 times ] |
|
20171125_222117.jpg [ 47.14 KiB | Viewed 280 times ] |
|
20171125_222144.jpg [ 44.27 KiB | Viewed 280 times ] |