| PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
| Starter rpm http://www.pilotodyssey.com/PO/viewtopic.php?f=1&t=17850 |
Page 1 of 1 |
| Author: | canadian oddy [ Sun Jan 21, 2018 4:13 pm ] |
| Post subject: | Starter rpm |
Anybody ever tach a starters rpm ?? Just curious what the rpm of an oddy starter is on a full battery. |
|
| Author: | adnoh [ Sun Jan 21, 2018 8:28 pm ] |
| Post subject: | Re: Starter rpm |
Yes I have and even videoed it. I do wet and dry cranking compression reading. I factor in rotation speed into the equations. I even pull vacume reading when doing it. Ody may be a little different than pilot. You should do some testing for fun. I found it interesting. |
|
| Author: | canadian oddy [ Sun Jan 21, 2018 8:33 pm ] |
| Post subject: | Re: Starter rpm |
adnoh wrote: Yes I have and even videoed it. I do wet and dry cranking compression reading. I factor in rotation speed into the equations. I even pull vacume reading when doing it. Ody may be a little different than pilot. You should do some testing for fun. I found it interesting. So the million dollar question is -- how did you do it ?? How do you get a reading and on what is it hooked to ?? I did do a vacuum pull on my brothers machine and mine. The vacuum changes with the mods done. I saw that on our machines. |
|
| Author: | canadian oddy [ Mon Aug 27, 2018 10:45 pm ] |
| Post subject: | Re: Starter rpm |
This is an old thread but want to bring it back to life for a moment. I don't remember why I wanted to know what rpm the starter spins the Engine but I just found out. I had to test my machine by running it down the street because of installing my homemade pucks in a 94c clutch. I had a tach hooked up to the coil wire. While I was cranking it the tach showed approx 450 rpm and then the machine started up. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|