Here's a homemade one an Aussie made:
http://pilotodyssey.com/PO/viewtopic.ph ... r+bugeye59Here's one BS did:
viewtopic.php?f=1&t=11366Note that he used backup nuts on the inside so you don't pull out the threads.
I think hoser was the one to come up with tapping the holes in it so that if you put a bolt in it then it will push the shivs apart so that you can easily put a new belt on.
Not sure of your youboob link but I bet it was someone from this site.
The best way to search this site is to type "one" word in the search box and hit enter.
When the list comes up, there will be another search box there that says "search these threads"
Type "one" word in that and hit enter.
Do this as many times as necessary to narrow it down to what you want.
Common words like Engine, wheel etc will be ignored.
If you put to many words in the search box then you get to many hits.
Also when you get to where you want, look at the very bottom of the link you clicked on. There will be many many similar threads to the one you are in.