Can anyone verify for me if the seals on a FL350 go in from the outside of the gearbox or the inside of the box ??
THX in advance for any replies.
CO

Here is a pic from the service manual, looks like they get installed from the outside:

Thx for the reply.
Yeah I got that pic on the wall in the shop and I see that too, but just wanted to make sure and if anyone has done one.
The reason I want to make sure is that I gave a new member here bad advice on his FL250 crank seals. Those one's go in from the inside apparently. Adnoh saved my azz on that one.
CO

I see...
Looking at the fl250 service manual it shows that the seals get put in from the inside. So I would say the gearbox seals getting put in from the outside is still a safe bet.

Sounds and looks good to me.
Outside In it is then.

Still can't put this gearbox together. A needle bearing is back ordered for 6 weeks and I still don't have those seals LOL.
CO

I install mine from the outside. I can get you the seals as well, I’ll get them sent to me and then send them to you, just say the word.

Thx for the info.
Thx for the offer.
These seals are just for the spare gearbox with the welded teeth on the AB and the repaired AB shaft. I got stuff coming but for some reason its delayed. Also the seals I got coming are not the correct ones (no metal shield) but its unlikely I'll ever have to run this gearbox. It's just an emergency spare.
I will keep that offer in mind though and reserve the right to call it in .
CO