I noticed I had lost a few slippers on my driven clutch... I see odyssey salvage has them for sale. Does anyone have any instructions on how to replace???

I bought a bag full from Ody Salvage a few years back. The simply press into the hole. You may need to use pliers to pull the old ones out. Twisting back and forth a little before pulling up seems to help to.

Sometimes they will break off leaving the plastic stud in the hole, you can heat up a welding rod and stick in the hole, once it cools then pull it out.

I haven't looked deep enough to see if the missing pieces are still stuck... Thanks for the tip. They have been missing awhile didn't seem to bother anything. I want to rebuild both the 102c and driven clutches eventually. Who sells the covers for the 102c??

Will I have to remove the driven to replace the slippers? Is there directions in the manual... you know the blonde hair and all...LOL

Remove your belt then rotate the clutch face away from the ramps the give you room to extract them. Three hands would be handy but not required.