hoser wrote:
Probably have to take apart the other side that is still good and measure it?
wouldn't the distance spacer for the inner race be the same as the distance between the outer race that is machined into the hub itself so their was no stress on your balls when you tighten the axle nut?
Check with
Mudbogger he probably has one in stock he can measure.
Stoneman has one that is off his basket case Pilot and apart?
from my numbers I get max of
OD 43mm (1.6928)
ID 35mm + (1.3779+)
24mm tall (.9449) this the number that matters height
Knuckle 68mm wide over all
bore on each side 24mm deep
bearing 14mm wide
seal 8 mm wide ?
this leave me with 20mm in the center of hosing
Thank you for your time
SpeedChaser