Hey guys. Tough week as far as problems. I need new rear axle bearings. Partzilla shows bearings as available but not the collar. Anyone know where I can get the collar?

I think I might have found what I need at Pivot Works. Waiting for them to open tomorrow

Hmm unless you have one in trouble usually the collars can be reused with the new bearings.

The collar is a little beat up. I'll clean it up and re use it

After cleaning up verify the width if its narrower than its suppose to be when assembled and the nut tighten it will put thrust on the balls of the bearings and they will not last long does the service manual list the width of the spacer?

Do a site search ?

https://www.google.com/search?q=Pilot+w ... AHoECAEQAA