PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
Harescrambles Basket Case Spare Pilot Engine. CSI http://www.pilotodyssey.com/PO/viewtopic.php?f=25&t=5451 |
Page 1 of 1 |
Author: | hoser [ Thu May 07, 2009 9:55 pm ] | ||||
Post subject: | Harescrambles Basket Case Spare Pilot Engine. CSI | ||||
Started on hares spare basket case Pilot Engine, it came in a bazillion pieces. The case have had a weld repair on the clutch side by the crank, nice looking repair job. The crank is nice and tight but it came with a bearing fused to the clutch side I had to grind it off to remove.
|
Author: | hoser [ Thu May 07, 2009 9:57 pm ] | ||||||
Post subject: | |||||||
Looks like this Engine had seen a rod failure in the past you can see where the rod hit the cases, I hoserized the cases for better oiling and lapped them they are nice and flat.
|
Author: | hoser [ Thu May 07, 2009 9:58 pm ] | |||||
Post subject: | ||||||
Crank installed in cases with new Honda bearings.
|
Author: | hoser [ Thu May 07, 2009 10:04 pm ] |
Post subject: | |
Before I can assemble any further I need a balancer if you remember I use the balancer out of this Engine for the K&N Filter HAIRY-ASS-Pilot CSI project. someone had modified that one and remove the balance weight I need to go through the rest of the pile of parts to see if their is anything else I need I am sure their are some nuts and bolts missing somewhere lol The right side case needs a few hours of cleaning up and rebuilding the water pump before its ready to install, all the rest of the parts are plenty dirty too. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |