PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
Stock Rod Length http://www.pilotodyssey.com/PO/viewtopic.php?f=31&t=16026 |
Page 1 of 1 |
Author: | FIRELS1 [ Mon Sep 14, 2015 9:47 am ] |
Post subject: | Stock Rod Length |
Anyone know what stock rod length is on a FL 250? |
Author: | hoser [ Mon Sep 14, 2015 1:22 pm ] |
Post subject: | Re: Stock Rod Length |
FIRELS1 wrote: Anyone know what stock rod length is on a FL 250? Check out ProX http://www.pro-x.com/ they should have a parts catalog that will list the rod and give the length. |
Author: | FIRELS1 [ Mon Sep 14, 2015 6:20 pm ] |
Post subject: | Re: Stock Rod Length |
Pro x doesn't even list the FL-250 in their catalog. |
Author: | adnoh [ Thu Sep 17, 2015 9:07 pm ] |
Post subject: | Re: Stock Rod Length |
Final found your info 121 center to center. here is what I found: 1977 FL250 A PISTON + CRANKSHAFT 1978 FL250 A PISTON + CRANKSHAFT 1979 FL250 A PISTON + CRANKSHAFT 1980 FL250 A PISTON + CRANKSHAFT 1981 FL250 A PISTON + CRANKSHAFT 1982 FL250 A PISTON + CRANKSHAFT 1983 FL250 A PISTON + CRANKSHAFT 1984 FL250 A PISTON + CRANKSHAFT 1974 CR250M A PISTON + CRANKSHAFT 1974 MT250 A PISTON + CRANKSHAFT 1975 CR250M A PISTON + CRANKSHAFT 1975 MT250 A PISTON + CRANKSHAFT 1976 CR250M A PISTON + CRANKSHAFT 1976 MT250 A PISTON + CRANKSHAFT 13201-357-300 121 center to center 31 mm big end 22 mm small end 16.75 big width 20 mm small width http://vintagedirtbikeforums.alp-sys.co ... ca0584f5db Allright guys here is the info on the rods. I measured both a stock and kit rod. I also looked at the spec sheet on the Wiseco site to make sure of my measurements. The stock rod is 121mm center to center, 31mm big end bore, 22mm small end bore, 16.75 bottom width, and a 20mm top width. The Wiseco rod kit WPR124 which fits 84 to 2001 CR250 along with some ATVs has the exact same measurements except for length. It is 125.3mm in length. SO it is 4.3mm longer and needs the spacer plate to make it work. Hope this helps someone. As I said before, $142 from Badbrush is not a bad deal when you figure the custom made spacer plate, but if you have it like I did and only need a rod it is nice to order from my local dealer who gets overnight service from a couple of his suppliers. Now what rod you got??? FYI the thrust washers are the same as the 350 and I did find in stock a rod and pin just no washers. Ill keep looking |
Author: | adnoh [ Thu Sep 17, 2015 9:35 pm ] | |||
Post subject: | Re: Stock Rod Length | |||
Forgot to add these pics
|
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |