PilotOdyssey.com
http://www.pilotodyssey.com/PO/

CR500 Cylinder Nukems
http://www.pilotodyssey.com/PO/viewtopic.php?f=32&t=8772		 Page 1 of 1
Author:  hoser [ Thu Feb 17, 2011 5:42 pm ]
Post subject:  CR500 Cylinder Nukems
Here is a CR500 cylinder of Nukems he bought for a CR500 project he has now decided not to do.

Needs bored for sure uneven cylinder wear reveled by using a Sunnen AN-112 ridged stone hone a flex hone will follow the uneven bore and not show this.

Attachments:
DSC08518.JPG [67.85 KiB]
Downloaded 72 times
DSC08519.JPG [79.98 KiB]
Downloaded 72 times
DSC08520.JPG [73.49 KiB]
Downloaded 72 times
DSC08521.JPG [61.69 KiB]
Downloaded 72 times
DSC08522.JPG [72.19 KiB]
Downloaded 72 times
DSC08523.JPG [86.69 KiB]
Downloaded 72 times
Author:  grimlocksteeth [ Sat May 18, 2013 12:19 pm ]
Post subject:  Re: CR500 Cylinder Nukems
What's the work involved in putting a cr500 top end on the top ofmy pilot Engine?
It looks like it needs are bore and new oversized piston anyway, so may go with putting a cr 500 top end on if its possible as I have a cr500 in the garage somewhere!! :-)thanks!
Author:  hoser [ Sat May 18, 2013 12:41 pm ]
Post subject:  Re: CR500 Cylinder Nukems
Lots of fab work required to put the CR500 cylinder on a Pilot you have to relocate the studs weld up then machine the cases to match etc.

I still have Nukems CR500 cylinder if anybody needs a spare I am pretty sure its still for sale.
Author:  grimlocksteeth [ Sat May 18, 2013 1:54 pm ]
Post subject:  Re: CR500 Cylinder Nukems
hoser wrote:
Lots of fab work required to put the CR500 cylinder on a Pilot you have to relocate the studs weld up then machine the cases to match etc.

I still have Nukems CR500 cylinder if anybody needs a spare I am pretty sure its still for sale.


I think postage may be the killer there!! :-/ is the results worth the effort? Or would you recommend the re bore and a o/s piston?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/