Found a tear in my intake boot between the carb and the reed cage. I am looking for a good one if anyone has an extra.


Shipping would be to canada


Thanks

Honda says they are discontinued but I have seen guys in Canada find discontinued parts try some of your dealers up their have them search the system see if you can find one.

http://www.partzilla.com/parts/detail/honda/HP-16210-VM0-000.html

A used one is probably not going to be much better than the one you have the rubber is 28 years old.

Ill stop by a dealer and see what they can tell me. Will this cause a lean condition if used? Are there any other options?

YES!

They are pricey but I have purchased several from OddAtv.com

Doesn't look like he has any available at the moment. I have a brand new manifold that is a straight shot into the cylinder for sale. It is for a CR250r but it's the same bolt pattern. You will have to do a slight modification to get it to work because the carb hits the left side tranny mount. I also have a reed spacer if you are interested.

Rand

Yes it will def lean out your 350...and your wallet!

If you still need a ning ning fix,try this.

Spread your crack and clean it well!
Smear a bit of fuel resistant sealer in ya crack,wipe around ya crack,then wrap it with some of that pull-stretch-it rubber tape.
Don't forget to also clean your crack from the inside of boot as well.
This should keep your crack in check for a while,till ya source another boot,and get ya back to a ning ning!

Make damn sure you crack is clean if not it can get to smelling funky! Baz, I can see you haven't lost you sense of humor!

Rand

Hmm. The crack cleaning sounds like an option. I may use that to atleast get a leak down test done. Thanks for that idea.

Joe @ oddatv still has the new ones. I ordered one from him. I didnt want to chance using my fixed one. The crack is right on the edge of the clamp.