Turbo I will post rest once finalized. I have changed the the bump bracket and secondary sterring brackets twice now. The first allowsed the hub to over rotate past center. I used a 3" center to center triagle for a 1 to 1 and found it was too quick. The chance alowed it to retain the stock set as on the 450. This should allow the it to achieve a tighter turning radius. No rod ends all tie rod ends. Since your odyssey sterring shaft is straight ( ends boltd under each other) The 3" triangler bracket may work. This would replace the the rode end slipper. That the part I feel may be causing one of your problems. Before reworking get all the data on front settings. If you do not have. purchase a angle finder. 6" torpedo levle 2' levle, tape measure,metal ruler, jack stands, pencle and pad of papper. Thes all can be bought a harbor freight or local inexpensive tool shop. Ten I will hellp map out your front end before any rework go you have base line for repair. The ront end seams to work and a an quick fix may turn you into a happy odysse owner. I will walk you thu the tie rod set up if you like. I can get tie rods cheap and then you can cut and rethread the right side to fit. Once there right I can have new HD made to that size or you can do a "H" mod to them. Each tie rod cost me 6 buck to cut up. Need four so that's only $24.00. The bump kit material cost $80.00 to build. I came up with a bolt up kit so it can be changed or repaired easy. So your estimated cost is would be $130.00 in material and $65.00 for tools. If I rember right you said this arm set up was based on the pilot front end. The bolt up kit also allows for a bump stop addition so you can dial in the over center lock. Once again quick fix. You may need a shock relocate bracket if the lever ratio is off. I will walk you through acuring this data as well. It not bad to do. First thing to do is clear your head and get a fresh look at it. Get measurments and forget the rest then start over.
Now use your pencle and paper and start doodling on how to fix. Make sure to note at top of page date and what part. Oh ya No more bad word on kit. Use the half full approach. You may just help a lot of people out that does not like the kit and help them be happy as well. Do not be afraid to bounce ideas off others. Have son look at and get idea. Ask the board ect. I myself got the honda shop and race track as well as chassie builders,
Engine buildrs, my Dad and Tobey. Somethimes the see it in a different light and see what I am missing. I,ll post a pic for you do review and ponder.