PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
Odyssey & Pilot rear caliper bracket http://www.pilotodyssey.com/PO/viewtopic.php?f=46&t=4011 |
Page 2 of 2 |
Author: | canadian oddy [ Mon Dec 08, 2014 7:33 pm ] |
Post subject: | Re: Odyssey & Pilot rear caliper bracket |
bugeye59 wrote: Yes they wear out in the sliding pin areas,plus in the brake rotor slot. I've had 2 calipers where a hole was worn right thru between the rotor slot and sliding pin. Depending on your riding ground conditions,sand,rocks,general crap get ground into that slot area/notch and eventually wear thru to the sliding pin hole. Then the crap enters the pin hole and wears that out too! Aaarggh! A better way of shielding/protecting that area needs to be addressed. I fixed up one calliper by rolling my own bush around a suitably sized drill bit shank, from a thin polished sheet of stainless steel. The SS sheet was just scrap from a kitchen flue,worked perfectly,but everytime I've tried to fix/fill the rotor slot hole,it does'nt last long. I have lots of pics of it in my threads,maybe the FL800/AC550pilot thread? I'll look. Thx for the reply. That answers it. Post the pics please when you get a chance. |
Author: | speedchaser [ Tue Dec 09, 2014 7:58 am ] |
Post subject: | Re: Odyssey & Pilot rear caliper bracket |
well if there is a call for the rebuild able Steel ones start a new thread if we can get MIN of 10 or more I will run them at the same price $145 free ship in U.S.A. I build the steel ones to fit the fl350 & fl400 thanks Speed |
Author: | Pilot bird [ Tue Dec 09, 2014 8:53 am ] |
Post subject: | Re: Odyssey & Pilot rear caliper bracket |
speedchaser wrote: well if there is a call for the rebuild able Steel ones start a new thread if we can get MIN of 10 or more I will run them at the same price $145 free ship in U.S.A. I build the steel ones to fit the fl350 & fl400 thanks Speed Count me in! :() Pilot please |
Author: | bugeye59 [ Sun Dec 14, 2014 9:16 am ] |
Post subject: | Re: Odyssey & Pilot rear caliper bracket |
I'm in! |
Page 2 of 2 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |