PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
Piston machining Fixture + movies http://www.pilotodyssey.com/PO/viewtopic.php?f=46&t=7470 |
Page 1 of 1 |
Author: | speedchaser [ Mon Jun 28, 2010 8:53 am ] | ||||||
Post subject: | Piston machining Fixture + movies | ||||||
worked on a holding fixture to hold pistons that have a 18mm pin and have room for a 20mm pin on other side for later did it vee block style so I could run different size pistons don't need to much holding power because not machining off a lot of material thanks For looking Speed
|
Author: | speedchaser [ Mon Jun 28, 2010 11:16 am ] |
Post subject: | |
http://www.youtube.com/watch?v=iPqecfddisw watch out it has a high pitch ring movie first pocket |
Author: | speedchaser [ Mon Jun 28, 2010 12:41 pm ] |
Post subject: | |
http://www.youtube.com/watch?v=ftVlzIQhasU second pocket |
Author: | adnoh [ Mon Jun 28, 2010 10:49 pm ] |
Post subject: | |
Very nice work. I just watched and watched and dreamed a little. Weighted the piston yet to get new number. |
Author: | bugeye59 [ Tue Jun 29, 2010 8:50 pm ] |
Post subject: | |
Well done,good job. Now can ya do the same to my BeerBelly.....and while ya at it test out your skills,carveme out a 6 pack? |
Author: | hoser [ Sat Jan 03, 2015 6:53 pm ] |
Post subject: | Re: Piston machining Fixture + movies |
Can you do this for Pilot pistons yet, I can send a old style Pilot piston with the cuts already made to model from. I would like to have this done to my Wolfskill LT Pilot Engine before I put the top end back together. Thanks. |
Author: | fully [ Sat Jan 03, 2015 9:08 pm ] |
Post subject: | Re: Piston machining Fixture + movies |
that's pretty cool |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |