PilotOdyssey.com
http://www.pilotodyssey.com/PO/

Piston machining Fixture + movies
http://www.pilotodyssey.com/PO/viewtopic.php?f=46&t=7470		 Page 1 of 1
Author:  speedchaser [ Mon Jun 28, 2010 8:53 am ]
Post subject:  Piston machining Fixture + movies
worked on a holding fixture to hold pistons that have a 18mm pin

and have room for a 20mm pin on other side for later

did it vee block style so I could run different size pistons

don't need to much holding power because not machining off a lot of material

thanks For looking

Speed

Attachments:
DSCN0137.JPG
DSCN0137.JPG [ 450.52 KiB | Viewed 10607 times ]
DSCN0139.jpg
DSCN0139.jpg [ 434.88 KiB | Viewed 10607 times ]
File comment: piston pin in block Easy to flip piston to machine other side :) with out moving fixture
DSCN0140.jpg
DSCN0140.jpg [ 52.8 KiB | Viewed 9959 times ]
File comment: custom washer to clear wiseco rib inside piston
DSCN0141.jpg
DSCN0141.jpg [ 71.58 KiB | Viewed 9959 times ]
DSCN0144.jpg
DSCN0144.jpg [ 72.87 KiB | Viewed 9959 times ]
Author:  speedchaser [ Mon Jun 28, 2010 11:16 am ]
Post subject: 
http://www.youtube.com/watch?v=iPqecfddisw
watch out it has a high pitch ring
movie first pocket
:-)
Author:  speedchaser [ Mon Jun 28, 2010 12:41 pm ]
Post subject: 
http://www.youtube.com/watch?v=ftVlzIQhasU

second pocket

:-)
Author:  adnoh [ Mon Jun 28, 2010 10:49 pm ]
Post subject: 
Very nice work. I just watched and watched and dreamed a little. Weighted the piston yet to get new number.
Author:  bugeye59 [ Tue Jun 29, 2010 8:50 pm ]
Post subject: 
Well done,good job.
Now can ya do the same to my BeerBelly.....and while ya at it test out your skills,carveme out a 6 pack? :-)
Author:  hoser [ Sat Jan 03, 2015 6:53 pm ]
Post subject:  Re: Piston machining Fixture + movies
Can you do this for Pilot pistons yet, I can send a old style Pilot piston with the cuts already made to model from. I would like to have this done to my Wolfskill LT Pilot Engine before I put the top end back together.

Thanks.
Author:  fully [ Sat Jan 03, 2015 9:08 pm ]
Post subject:  Re: Piston machining Fixture + movies
that's pretty cool
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/