As you know I came into a FL350 project that may take awhile. Ordered a water cooled head off eBay and I have to get a bore and piston job done. I have been trying to do a pressure test and so far I haven’t been able to hold pressure for 6 minutes at 6 Pounds. So I thought I would work on the gas tank pick up tubes. I got the old tubes out and made a small plate for the new tubes to weld to. Tig weld ?? Hopefully. Does this look like it will work? I’m thinking I have to just pull
Engine out so I can see everything real well when I spray it with soapy water. Might be seal under cover under Recoil cover?
Do you think my pick up tubes are the correct length?