After some researching and looking for a better way to mount it I was stumped. I thought about casting some mounts, but I’ve tried that and it took about a week to cure. Then I went into my garage and found a dollar tree rubber mallet that was Lying around. 5 minutes with a drill and a hacksaw and I have new rear motor (( Internal Combustion Engine ? )) mounts. I also found some unopened bushings for an Isuzu pickup that I used to have. So in the end I’ll have 5 mounting points for my Engine and they should be plenty stiff and sturdy. I plan on welding reinforcement to all of the previous motor (( Internal Combustion Engine ? )) mounts as well.