Joined: Mon Jun 15, 2009 3:05 am Posts: 1228 Location: Chicago
|
ok... ill start off with a disclaimer.
I am terrible at fabricating things.
But I roughly measured the 350 tub (from the front base up and out) and decided to butcher it with the dremel today.
The fiberglass started to irritate my arms so i quit before the job was done. The angle on the 250 steering column is all wrong for the 350. I Think I am going to remove it completely and make a sheet metal cover for around the column.
Attachments: |
File comment: FL250 Odyssey
IMG_0751[1].JPG [ 2.75 MiB | Viewed 311 times ]
|
|
|