PilotOdyssey.com http://www.pilotodyssey.com/PO/ |
|
BS's 617 rotax pilot swap http://www.pilotodyssey.com/PO/viewtopic.php?f=61&t=14809 |
Page 3 of 3 |
Author: | DMoneyAllstar [ Fri Mar 27, 2015 3:35 pm ] |
Post subject: | Re: BS's 617 rotax pilot swap |
B S wrote: nope its not 5/8 ordered a M16 x 1.5 Sh!t! I didn't see your question about the removal tool threads. I've got one and will check the thread and pitch when I get home. If you want to service a SkiDoo TRA clutch, you also need the set of (3) little steel shims to keep things from falling apart. |
Author: | DMoneyAllstar [ Fri Mar 27, 2015 6:44 pm ] |
Post subject: | Re: BS's 617 rotax pilot swap |
The one I have is M14 x 1.0. It's like 0.560" OD. There is a version with the threads by the hex, and then another with th e threads in the middle of the shaft. |
Author: | B S [ Mon May 18, 2015 3:19 pm ] |
Post subject: | Re: BS's 617 rotax pilot swap |
http://www.ebay.com/itm/270828372126?_t ... EBIDX%3AIT |
Author: | Kuma [ Mon May 18, 2015 3:23 pm ] |
Post subject: | Re: BS's 617 rotax pilot swap |
CLUTCH PULLER SKI-DOO FITS ALL 85-95 TWIN CYLINDER MODELS WITH T.R.A CLUTCH EXCEPT 617 & 670: 'says it will not work on 617 & 670s couldn't you do this a whole lot less with a bolt and a piece of drill rod? |
Author: | B S [ Mon May 18, 2015 4:14 pm ] |
Post subject: | Re: BS's 617 rotax pilot swap |
Kuma wrote: CLUTCH PULLER SKI-DOO FITS ALL 85-95 TWIN CYLINDER MODELS WITH T.R.A CLUTCH EXCEPT 617 & 670: 'says it will not work on 617 & 670s couldn't you do this a whole lot less with a bolt and a piece of drill rod? my clutch is off of a skidoo 377 |
Author: | B S [ Thu May 28, 2015 11:52 am ] |
Post subject: | Re: BS's 617 rotax pilot swap |
well got the clutch machined changed out the jets in the carbs to the correct ones 50 pilot 135 main 18 psi pop off pressure had to install new gaskets in the exhaust manifold just got my replacement headlight from eBay one of the new 7'' hid was DOA when i ordered them months ago all i have to do i a little bit of wiring and install the plastic and i should me good to go |
Page 3 of 3 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |