there is a very long story regarding problems with my pilot i bought from a friend. you can read on my previous post regarding my crankshaft problem. I have the replacement crank and this week have torn down the
motor ((
Internal Combustion Engine ? )) and when I got to the case I noticed both halves were pretty gouged out in the center where probably the rod had rubbed in the past when the lower bearing had failed and had been replaced. I didnt think that was a huge deal until I saw a crack in the right half at the edge where the halves meet. I will post pics but I figure I'm done. already spent over $650 on parts to replace the ones that were obviously ruined before the case was opened. Any ideas would be appreciated.