So things are not working out for me
:(
Got the electrical parts in from Nick.Decided to jack the back wheels off the ground to do testing rather then driving it up and down the street and pissing off the neighbors.
So first test was to see if it would still miss at full throttle with wheels jacked up just like it would if I was driving it,and it did.
So I thought the first thing I would switch out would be the coil. So I hooked up the coil that Nick sent me and it was still missing. So I remembered that CO Asked me if I had change the spark plug and I had not so I went ahead and change the plug and did another test and it was still missing.
I just got a brand new belt in the mail so I went ahead and installed it while I was messing around.
Did Another test only this time I decided instead of going straight to full throttle to take it up to half throttle and hold it there for about 10 seconds and then slowly go to full throttle from there,and I did and it didn’t miss! So hmmm wtf? I did that a couple times with same success so then I tried it Giving it full throttle right from the get go and it had a little miss for a second or so but then cleared out And was running great without a miss at full throttle. So when I get off throttle and it’s idling I start hearing a screeching noise that sounds like it’s coming from the clutch,so I blip the throttle and it stops.
So then I decide to put my old coil back on and see if it will miss again at full throttle or if the new coil fixed the problem. So With old coil installed I take it up to half throttle for about 10 seconds and then go in it and it’s not missing now either,wtf? Why is it suddenly not missing? So I take it up to full throttle right from the get go and it’s not missing! So I let off the throttle back down to idle and the clutch is screeching loud as hell again. So I spray some comet clutch lube on it to see if that will do anything,It does not. The screeching is not constant, only at idle, and if you blip the throttle it will go away.
So now the bad part.I start it again And this time it revs up on its own like I’ve got throttle pegged but I’m not giving it any gas,I scrambled to hit the off switch as fast as I can,and after I shut it down when
Engine stops completely it sounds like something is still spinning inside.So I started again but this time taking video and it does the exact same thing again.So I don’t know what happened, if it’s developed a massive air leak somewhere, if I spun the crank bearing somehow,I don’t know.
If I grab clutch with both hands and try to wiggle it it is tight and doesn’t feel like anything is wrong.
I did a compression test and compression is still over 190.Fock!!!