Once upon a time, a company named FARR made and sold many aftermarket parts for Honda UTV. Among these was an Engine mount used to convert the Pilot to use a Rotax Engine. I guess the owner retired, but upon retiring, he made available all his technical drawings used to make his parts. I’m looking for a drawing for the Pilot Rotax Engine mount conversion. Any help would be greatly appreciated.

Steve

Cant help with drawings, but Methodical Fabricator is making these now. You can find him on these forums or through the Facebook groups for Pilots/Odysseys.

ya Methodical is making them, I don't recall seeing the pilot mount shared but there is one for the oddy.
I made one for pilot for a 583/670, I believe the mount is different for the 600 and 800, if you are a welder I could help you with a DIY setup if you want to buy one ready to go Meth is your guy.

I make them for the oddy and Pilot. Both are based on Manny's design, however I've made changes after receiving feed back from customers. For the oddy 583/670 style Engine, Pilot IS 600/700/800 and also one for the Pilot for 583/670. Also the starter mount. Been doing exhausts as well. and....splining axles and making FL350 billet side covers and custom oddy axle cv cups. Actually come to think of it, I've been busy. There's a whole lot more I've been doing.